I had these thoughts when I saw your x-rays first as well. You have a molar class II bite, that has been compensated by extraction in the upper jaw. So the bite fits, but in class II. I'm not sure how they normally handle a case like that. One option could be to accept the class II occlusion and displace the entire complex, but not sure if they do that. You'd have to get an expert opinion. It could be that they can decompensate to give space to advance the mandible. But it could also be that they have to make space, either by extraction in the lower jaw, or reverse the extraction in the upper jaw and put implants. I don't know what your extraction case looked like, but likely the teeth were extracted to reduce the arch in the upper jaw, which is the opposite of what you want to do when you want to open up to give space for the mandible to be moved to class I from class II.
First of all, thank you for a reply!
Well that’s exactly what my thoughts were. I had class II division I, where the upper incisors were greatly tipped out. What worries me the most is the lower incisor tipping, I believe that if they can decompensate it without extractions, then I may have a shot, if not, then lower premolars will have to go. I’ve read some articles about a case similar to mine where no further extractions were necessary, and the needed space was acquired by CCW rotation and a bit of lower arch decompensation.
A factor that gives me hope is that my occlusion stood quite firm after the orthodontics, almost no relapse even though I didn’t wear a retainer in more than 4 years, according to the comparison of old and new X-rays, except for some minor lower incisors tipping.
Last but not least, as you’ve mentioned, an expert opinion will be required to set it down.
Thanks again for taking your time to write a reply!